Sov's Quest for Watercooling-warning pictures-

[soven]

Slow ghetto project , just doing it when I am free. Suggestions, tips or even donations would be good :D

My initial setup:
Setup:-
http://www.soven.orcon.net.nz/setup.jpg

Reservoir used:- http://www.soven.orcon.net.nz/res.jpg
Leak test:- http://www.soven.orcon.net.nz/test.jpg
Block:- http://www.soven.orcon.net.nz/Close-up%20Block.jpg


However I wasnt happy and wanted to fit the huge heatercore into the small case.

This is what I am doing now

Poor case:- http://www.soven.orcon.net.nz/Casecutting1.jpg

120mm intake:-
http://www.soven.orcon.net.nz/120mm_intake.jpg

http://www.soven.orcon.net.nz/120mm_intake1.jpg

Trying to add another 120mm now... to be continued, tips pls.

[edit] I am also trying to change the direction the barbs is facing, I want it to face inside instead of sideways.

[dumass]

maybe get a work bench.

I personally hate working on the floor. your back must be killing you!

[Sodge]

Good to see my old case has been put to good use ;) :D

[Joshsti_NZ]

Errm, that heatercore looks a tad to big to fit in that case, I don't think you'll be able to put the side panels back on with the tubing :p, but I dunno.

Looks good anyway

*bows down to the Darkrider full tower*

[Method]

mint rad man ;p

[soven]

Originally posted by Joshsti_NZ
Errm, that heatercore looks a tad to big to fit in that case, I don't think you'll be able to put the side panels back on with the tubing :p, but I dunno.

Looks good anyway

*bows down to the Darkrider full tower*

At the moment no , but I am trying to cut off the barb comint out of heater core, seal the hole and then drill another hole and epoxy a barb into it which is facing inwards.Ok heres where I need help, would this be do-able or is the original barb connecting to something inside the heatercore?

Either that or I would have to cut the motherboard holder(??) and it would just fit if i shorten the barb on the left somemore and maybe use a elbow to connect the tubing.

[Joshsti_NZ]

Oooer, you should make a hole in the side panel for the barb so it sticks out, attach the tubing which feeds though another hole but do it with you're 1337357 styleeeez so it looks really wicked ...

[soven]

Originally posted by Joshsti_NZ
Oooer, you should make a hole in the side panel for the barb so it sticks out, attach the tubing which feeds though another hole but do it with you're 1337357 styleeeez so it looks really wicked ...

I dont have the holesaw attachment :(

[Joshsti_NZ]

Noooo, you must beg, borrow or steal it from another OCNZ member!